Configure SNMP Settings
Use the SNMP settings for enterprise monitoring tools to monitor the health and status of the UAG appliance.
- In the admin UI, click Integrations in the left navigation pane.
- In the SNMP Settings card, click Configure.
- Enter the following details and click Save.
| Setting | Description |
|---|---|
| Enable SNMP | Turn on this toggle to enable SNMP service. Simple Network Management Protocol collects system statistics, memory, disk space usage statistics, and Tunnel edge service MIB information by Unified Access Gateway. The list of available Management Information Base (MIB): - UCD-SNMP-MIB::systemStats - UCD-SNMP-MIB::memory - UCD-SNMP-MIB::dskTable |
| SNMP Version | Select the desired SNMP version. If SNMPv1+v2 is selected as the SNMP protocol, you can add a custom SNMP community name. Note: You must enable SNMP before configuring Tunnel. If you enable SNMP after configuring Tunnel, you must re-save the Tunnel settings for the SNMP settings to take effect. If you have deployed Unified Access Gateway through PowerShell, enabled SNMP, but not configured SNMPv3 settings either through PowerShell or the Unified Access Gateway Admin UI, then by default SNMPv1+SNMPV2c versions are used. Here are the additional steps for configuring the SNMPv3 settings in the Admin UI: 1. Enter SNMPv3 USM User 2. Enter SNMP Engine ID. This value is unique for each Unified Access Gateway appliance. The maximum length of the engine ID is limited to 27 characters. 3. Select SNMPv3 Security Level. 4. Depending on the security level selected in the previous step, perform the following actions: SNMPv3 Security Level No Auth, No Priv (No Authentication, No Privacy) Click Save. No further actions are necessary. Auth, No Priv (Authentication, No Privacy) 1. Select SNMPv3 Auth Algorithm 2. Enter SNMPv3 Auth Password. Password must be at least 8 characters long. 3. Confirm Auth Password entered in the previous step. 4. Click Save. Auth, Priv (Authentication, Privacy) 1. Select SNMPv3 Auth Algorithm The supported values are: MD5 (Not Recommended), SHA (Not Recommended), SHA-224, SHA-256, SHA-384, SHA-5122. Enter SNMPv3 Auth Password. Password must be at least 8 characters long. 3. Confirm Auth Password entered in the previous step. 4. Select SNMPv3 Privacy Algorithm. Supported values are DES, AES.5. Enter SNMPv3 Privacy Password. Password must be at least 8 characters long. 6. Confirm Privacy Password entered in the previous step. 7. Click Save. |
| SNMP Community | Enter a custom SNMP community name to be used. If this field is left blank, "public" is used. |
War diese Seite hilfreich?