You can update your Omnissa Access connector installation at any time to add or remove services, or to modify the existing configuration. Run the installer again to make any changes.
The installer supports a range of updates to an existing connector without requiring a full reinstallation. You can add enterprise services (Directory Sync, User Auth, Kerberos Auth, or Virtual App), change the ports each service runs on, configure or update proxy and syslog server settings, install or replace SSL certificates, and update the domain user account used to run the Kerberos Auth and Virtual App services.
Adding or modifying services and deleting services are separate operations. You cannot perform both in the same installer session.
In This Section
-
Adding or Modifying Enterprise Services on the Omnissa Access Connector
Run the installer to add enterprise services to the connector or to update the existing configuration, including service ports, SSL certificates, trusted root certificates, proxy settings, syslog servers, and the domain user account for the Kerberos Auth and Virtual App services. If you are modifying an existing configuration, suspend the affected services from the Omnissa Access console before running the installer.
-
Deleting an Enterprise Service from the Omnissa Access Connector
Remove a specific enterprise service from the connector without uninstalling the connector itself. Before deleting a service from the Windows server, delete it from the Omnissa Access console. Services can be reinstalled on the connector at a later time if needed.
Was this page helpful?