If a node in the Omnissa Access cluster is not functioning correctly and you are unable to recover it, you can remove it from the cluster with the Remove Node command. The command removes the node entries from the Omnissa Access database.
You can check the health of the nodes in your cluster by viewing their status in the Monitor > Resiliency page in the console. A The current node is in a bad state message indicates that the node is not functioning correctly.
Important: Use the Remove Node command sparingly. Only use it when a node is in an unrecoverable state and must be removed completely from the Omnissa Access deployment.
Note: You cannot use the Remove Node command to remove the last node in a cluster.
What to read next
- Remove the Omnissa Access Node from the Cluster
You can remove the node from the cluster.
このページは役に立ちましたか?