(Optional) Add IP Pools to the Omnissa Access Virtual Appliance

Network configuration with IP Pools is optional in Omnissa Access. You can manually add IP pools to the Omnissa Access virtual appliance after the appliance is installed.

IP Pools act like DHCP servers to assign IP addresses from the pool to the Omnissa Access virtual appliance. To use IP Pools, you edit the virtual appliance networking properties to change the properties to dynamic properties and configure the netmask, gateway, and DNS settings.

Prerequisites

The virtual appliance must be powered off.

Procedure

1. In the vSphere Client, select the Omnissa Access virtual appliance to update.

2. Select Configure and navigate to the Settings > vApp Options > Properties pane.

3. Configure each of the following keys.

   - vami.DNS.WorkspaceOneAccess
   
   - vami.netmask0.WorkspaceOneAccess
   
   - vami.ip0.WorkspaceOneAccess
   
   - vami.hostname
   
   - vm.vmname
   
   - vami.gateway.WorkspaceOneAccess
   
   - vami.searchpath.WorkspaceOneAccess
   
   - vami.domain.WorkspaceOneAccess
   
   1. Select one of the keys and click **Edit**.
   
   2. In the Edit property dialog box, select **Type** and then select **Dynamic Property**.
   
   3. Select the appropriate value from the drop down menu for **Netmask**, **Gateway Address**, and **DNS Servers** respectively.
   
   4. Click **OK**, and click **OK** again.
   
   5. Repeat these steps to configure each key.
   

4. Power on the virtual appliance.

Results

The properties are configured to use IP Pools.

Configure Omnissa Access settings.

Related information

Use the Setup Wizard to Finish Configuring the Omnissa Access Appliance