Create Remote Access Template in Omnissa Access (On Premises only)

You can create a template to enable a group of clients to register dynamically with the Omnissa Access service to allow users access to a specific application.

Procedure

1. Navigate to the Omnissa Access console Settings > Remote App Access page.

2. Click Templates.

3. Click Create Template.

4. On the Create Template page, enter the following information about the application.

   Label	Description
   Template ID	Enter a unique name that identifies this template.
   Application	Select Identity Manager
   Scope	Select the information that the token contains. When you select NAAPS, OpenID is also selected.
   Redirect URI	Enter the registered redirect URI.
   Advanced Section	Click Advanced.
   Token Type	Select Bearer. This attribute tells the application what type of access token it was given. For Omnissa Access, the tokens are bearer tokens.
   Token Length	Leave the default setting, 32 Bytes.
   Issue Refresh Token	To use refresh tokens, leave this option enabled.
   Access Token TTL	Set the access token time to live length. The access token expires based on the TTL set in Access Token Time-To-Live. If Issue Refresh Token is enabled, when the access token expires, the application uses the refresh token to request a new access token.
   Refresh Token TTL	Set the Refresh Token time to live. New access tokens can be requested until the refresh token expires.
   Idle Token Time-to-Live (TTL)	Configure how long a refresh token can be idle before it cannot be used again.
   User Grant	Do not check Prompt users for access.

5. Click Add.

What to do next

In the resource application, set up the Omnissa Access service URL as the site that supports integrated authentication.